Zitat von »Mathijs Kok«

First images...











[Quelle: Aerosoft-Forum]

Zitat von »Jarschi«

Gab's nicht für den FS9 eine recht brauchbare Freeware??

Zitat von »Mathijs Kok (Aerosoft)«

[...] System wise she is also shaping up very well. The engine modeling is I think the best ever done for turbo props. Just a bit better then PMDG did it recently (but of course we looked carefully how they done it and they assisted us as well)

• Starter motor failure due to overtorque if trying to start with feathered props.
  
• Battery gets hot when overloaded - mainly due to running both starters or trying to start with feathered props.
  
• Hung starts - if fuel is introduced before Ng reaches 10% then there is 1/3 chance that the engine get hung ie. it cannot be started again.
  
• Hot starts - if fuel is introduced before Ng reaches 10% then there is 1/3 chance that the engine experiences a hot start - i.e combustion chambers and other engine parts are melted also causing engine fire.
  
• Engine failure due to overtorque
  
• Engine fires occur when overtorque failure occurs.
  
• Engine fires can be extinguished with the Fire Handles / Fire ext (squib) switch
  
• Engine flame outs MIGHT occur in heavy precipitation if Continuous ignition switches are not switched on.

Zitat von »Mathijs Kok (Aerosoft)«

Bronco feature list

• Highly realistic modelled Garret T-76 (Honeywell TPE331) engines (best turbo prop simulation in FSX to date)
  
• Realistic start-up sequence with propeller start-latches and engine instrument readouts.
  
• Realistic in-air restarts possible (normally not possible in FSX).
  
• Custom propeller animations.
  
• Hot and hung starts (clearing engine after a hung start possible) .
  
• Engine failures due to over torque or overheat.
  
• Engine flame outs due to icing when not using continuous ignition.
  
• Working fire extinguishers.
  
• Electrical system fully custom coded with electrical load calculated for every consumer.
  
• All aircraft lights are dependent on correct electrical setup.
  
• Realistic landing lights that actually light up scenery.
  
• Gauge needles vibrate due to uneven ground and aircraft vibrations.
  
• Airspeed gauge needle vibrates close to stall speed.
  
• Lots of animations like oil cooler doors, Ram door, canopy, windscreen wiper etc..
  
• Smoke effects for engine fire, hung engine and smoke generator on left engine.
  
• Fully working TACAN radio and additional modern COM2 radio
  
• Fully functional Becker BXP 6401 transponder
  
• Custom developed GPS with map mode, direct to mode, cursor mode,nearest station mode, hsi mode
  
• Unique Checklist Gauge with the option to let the checklist do the required actions.
  
• Engineer station gauge to visualize the electrical system state.
  
• Hundreds of nonstandard sounds.
  
• Created with the support of the OV-10 Bronco Association, German Wing.
  
• Highly realistic flight model (several test flights were done in the real aircraft to verify the simulated model). Flight modelling includes realistic stalls and spins.

[Quelle: Aerosoft-Forum]

Zitat von »Nick C«

[Quelle: Aerosoft-Forum]