Zitat von »hasegawa«

Deshalb ist es mir eher egal, ob sie kommt oder nicht. Es muss schon ein herausragendes Produkt sein, wenn ich sie in meinen ohnehin zu vollen Hangar einstelle. Aber das ist meine Meinung und es gibt genug gute Gruende, um dies anders zu sehen.

Zitat von »hhoelscher«

Vitus, der auch ein paar Sachen an der Katana programmiert hat, schrieb kürzlich aus Neuseeland seine ersten Eindrücke bei uns im Forum. http://www.bush-pilots.net/viewtopic.php?t=6179

Zitat von »hasegawa«

Es muss schon ein herausragendes Produkt sein, wenn ich sie in meinen ohnehin zu vollen Hangar einstelle.

Zitat von »Mathijs Kok (Aerosoft)«

Modes
Realistic
- Wear and damage can encounter and will be stored. Fluids will be used and the aircraft can get dirty. Maintenance and services are available. Flight hours and landings will be counted and special features unlocked.
Simple
- No wear and damage will be simulated. Aircraft stays clean. Flight hours and landings are not locked. No special features.
Instructor
Aircraft is as new every reload. Wear and damage can encounter or be triggered but will not be stored. Fluids will be used and the aircraft can get dirty. Flight hours and landings will not be counted and no special features are available. Instructor Panels are available.

Airframe
- Airframe limitations are simulated
- Trim tabs can be bend on ground
- Controls can get damaged
- Controls can freeze
- Flaps can get damaged
- Flaps motor can get damaged
- Wheel fairings can be attached/detached
- Wheel fairings can get damaged
- Aircraft can get dirty
- Canopy can be opened and closed stepless
- Canopy can be opened and closed by airflow
- Canopy locking mechanism
- Canopy can break off
- Canopy can get covered by ice
- Elevator can get damaged by canopy
- Cowling can be opened
- Oil Access Door can be opened
- Fuel Tank Cover can be opened

Engine (Rotax 912S)
- Engine damage and wear
- Engine cooling by air and fluid
- Carburetor Simulation
- Carburetor can get plugged
- Carb Heat
- Starter simulation
- Starter can get damaged
- Starter low voltage simulation
- Engine Start due Windmilling
- Engine Start due turning the Propeller by hand
- Choke Simulation
- Engine Windmilling

Propeller
- Propeller damage and wear
- Propeller Governor simulated
- Propeller ground contact
- Propeller damage by dust
- Propeller turnable by hand
- Propeller pitch change by hand

Oil System
- Oil usage simulated
- Two sorts of Oil: SAE20 / SAE40
- Oil quantity check
- Turning propeller or running engine draws oil out of the cylinders
- Oil Filter
- Oil temperature and pressure simulation

Fuel System
- Carburetor simulation
- Fuel pumps and pipes simulation
- Fuel in pipes can be burned
- Fueling simulation
- Fuel dip stick
- Fuel tank cover
- Water in fuel
- Water draining

Electrical System
- Complex Battery simulation
- Complete Elec Circuits
- Switches
- Relays
- Circuit Breakers
- Generator simulation
- Generator wear and damage
- Displays flicker and brightness
- Elec power on starter simulated

Instrumentation
- 3d Gauges with smooth animations
- Needle movements and vibrations simulated
- Gyros simulated
- Attitude Indicator simulation
- Compass card simulation
- Wet Compass acceleration and turning error
- Pitot Tube and Static Port simulation
- Pitot Tube, Static Port and Stall Warning can get plugged

Avionics
- Units operation simulted: Navigation and Communication is only possible with operating devices
- Simple mode: Units can be operated in simple mode for being compatible with hardware

- KX125 TSO
- Unit can be turned off
- Unit has circuit breaker
- Unit can be damaged
- Frequencies are stored
- Standby frequencies
- Engaging direct frequency control due holding the transfer buttons
- Modes: CDI, BRG and RAD
- Auto-TO
- Independant OBS display

- KT76A
- Unit can be turned off
- Unit can be damaged
- Unit has circuit breaker
- Transponder warmup simulated

- GPS500 (FSX default)
- Unit can be turned off
- Unit has circuit breaker
- Brightness can be adjusted

- GNS530 (by Reality XP, not included in the product)
- GPS500 can be replaced by the GNS530 directly in the simulator

Environment
- Cabin temperature simulated
- Cabin airflow simulated
- Wing icing
- Stall warning icing
- Controls icing
- Canopy icing
- Pitot and static port icing
- Dirt
- Insects

Visual Effects
- Motion and vibration effects
- Aircraft and parts influenced by propeller wind
- Realistic and switchable lighting effects
- Adjustable panel lighting
- Bumpmapping on exterior and virtual cockpit

Sound Effects
- Complex sound enviroment
- Every lever, switch has its own sound

Graphical User Interface
- All settings can be done in FSX

Preflight Panels
- Ground equipment and fixation
- Towbar
- Walkaround check
- Trim tabs
- Fuel station, fuel drain and dipstick
- Oil and liquids
- Payload
- Aircraft cleaning

Maintenance Panels
- Equipment: Change avionics or attach/detach wheel fairings
- Workshop: Inspection, repairing or replacing parts and systems
- Service: Replace or refill liquids, replacing or reloading battery etc.

[Quelle: Aerosoft-Forum]

Zitat

Cabin temperature simulated